Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in League City?
Duct repair and sealing in League City typically costs $285 to $1,450, with most single-home jobs landing between $400 and $850. Small sealing jobs on accessible duct runs sit at the low end, while repairs to disconnected trunk lines or ducts buried in attic insulation push toward the top. The written estimate sets the final price, and we give that estimate free.
We handle air duct cleaning, dryer vent cleaning, and duct repair across League City. Repair is the part most companies skip. We clean ducts. We also fix them.
Key Takeaways
- Typical League City duct repair and sealing range: $285 – $1,450, with most jobs near $400 – $850.
- Sealing alone (mastic or aerosol) runs around $285 – $650; reconnecting a disconnected run jumps to $350 – $900.
- Ducts in a hot, humid attic fail at joints and flex connections far more often than the metal itself.
- Repair found during a cleaning visit can usually be handled in the same trip.
- Estimates are free. Call (866) 942-5170.
Duct Repair & Sealing Cost Breakdown (2026)
Below are the typical estimated ranges we see in the League City market. Every job is priced per job from a written estimate, so treat these as starting ranges, not quotes.
| Line Item | Typical Estimate | What It Covers |
|---|---|---|
| Sealing accessible joints and seams (mastic) | $285 – $650 | Brush-applied sealant at plenum, trunk, and exposed branch joints |
| Aerosol sealing of a whole duct system | $550 – $1,250 | Pressurized sealant injected through the system to close small leaks |
| Reconnect a disconnected or collapsed flex run | $350 – $900 | Refit or replace one run and re-tape and mastic at both ends |
| Repair or replace a section of damaged trunk | $400 – $1,450 | Cut out a failed section, rebuild with sealed connections |
| Replace crushed or torn flex duct (per run) | $150 – $350 | Reroute and secure a run pinched by framing or storage |
| Seal and insulate ducts in an attic | $650 – $1,450 | Access, sealing, and re-wrapping runs exposed to attic heat |
| Repair found during a duct cleaning visit | Repair price only | No separate trip; the repair is folded into the same service call |
What drives the number up: how much of the ductwork you can actually reach. A system with open attic access and labeled flex runs is a different job from one where half the trunk sits under blown insulation or behind sheetrock. The number of separate leaks matters too. One disconnected run is a straightforward fix. Ten leaking joints across three branches is a sealing project. Duct material plays a role as well: sealed sheet metal holds up, while old flex duct that has sagged and torn gets replaced rather than patched. System size pushes cost up as well, since a two-story home with multiple returns has more joints to reach than a single-story layout.
What Affects Duct Repair & Sealing Pricing in League City
League City sits on the warm, humid side of the Texas Gulf region, and the houses here show it. Attics get brutally hot for most of the year. That heat bakes flex duct, dries out old tape adhesive, and loosens the sealant at joints. Humidity does the rest inside the living space. Once a joint opens, cool conditioned air escapes into the attic and pulls warm, damp outside air back through the gap. That cycle is why we see so many failed connections around here rather than failed metal.
- Attic heat and aging flex duct. Flex runs in a League City attic can sag under their own weight over a few summers. A sagging run pinches airflow and stresses the connection at each end.
- Access to the ductwork. Open attic access keeps labor low. Ducts boxed in or buried under blown insulation take longer, and that shows up in the estimate.
- How many leaks and where they are. A handful of accessible joints is a sealing job. Leaks behind walls or under flooring raise the price because reaching them is the real work.
- Whether the ducts are also contaminated. Ducts affected by mold or heavy debris need containment work and cleanup before repair. We use Abatement Technologies containment equipment for exactly that.
- Sizing and layout of the system. More returns, multiple zones, and two-story runs all mean more connections to seal.
- Filtration and air quality equipment already installed. If you have a Honeywell or Aprilaire system in the house, we work around it without damaging or bypassing it. That includes cabinet filters, media filters, and any inline components.
- Whether cleaning is needed alongside repair. If the system has never been cleaned properly, sealing old debris in place makes no sense. We fix the ducts and clean them in one visit where the job allows.
Does Duct Sealing Really Save Money in League City?
Yes. Sealed ducts keep conditioned air inside the house instead of venting it into the attic, and that shows up on your electric bill in a climate where the air conditioner runs most of the year. A leaking joint is a hole in your cooling budget. Sealing also helps the air conditioner itself by reducing how hard it works to reach the thermostat setpoint.
We won’t promise a savings percentage, because every house is different. What we can say is that a system losing air through open joints is spending money to cool an attic. Sealing closes those leaks. Fixing a disconnected run restores airflow to rooms that were always too warm. Those are measurable results, not sales lines.
How Does Duct Repair Work?
Repair starts with finding the leaks. We inspect accessible ductwork, check the connections at the plenum, trunks, and branches, and look at the condition of every run we can reach. Where the duct is contaminated, we set containment first. Rotobrush mechanical brush-and-vacuum equipment loosens debris that suction alone can’t move, and Nikro HEPA-rated vacuums pull fine particles out and hold them at the source instead of blowing them back into the house.
Once the ducts are clean and clear, the repair begins. Loose joints get brushed with mastic, not foil tape alone, because tape fails first in attic heat. Disconnected flex runs get reconnected securely at both ends. Crushed or torn runs get replaced. Damaged sections of trunk get cut out and rebuilt. Then we seal the system across the joints we can reach and check that the connections hold.
If you want the full picture of what a cleaning visit involves and how it pairs with repair, see our duct cleaning page. Duct work that reaches into electrical components or gas appliances is where we stop and hand off to a licensed electrician or HVAC technician. We don’t touch the furnace, coil, or electrical panel. Those components need a trained professional, and the danger is real.
How to Save on Duct Repair & Sealing
- Get the estimate first. A free written estimate tells you what you’re paying for. Call (866) 942-5170 and we’ll come out and price it.
- Combine repair with cleaning. If the ducts are due for cleaning, doing it in the same visit saves you a second call-out and a second round of prep.
- Fix the root cause, not the symptom. A single joint that keeps opening usually means a run is sagging or pinched. Sealing it again without fixing the pull just repeats the problem.
- Ask for the runs by name. Knowing which branch supplies which room helps you decide what matters most and what can wait.
- Don’t postpone a disconnected run. An open joint pulls attic air into the house. That’s a comfort issue and an air quality issue at the same time.
Save yourself the guesswork. Estimates are free, and pricing is per job from a written estimate, so you’ll know the number before any work begins.
FAQs – Duct Repair & Sealing Cost
How much does duct sealing cost in League City?
Duct sealing in League City typically runs $285 – $650 for mastic sealing on accessible joints, and $550 – $1,250 for a full aerosol seal of the system. The range depends on how many joints are reachable and whether the ducts are contaminated. Call (866) 942-5170 for a free estimate.
Is it cheaper to repair or replace ductwork?
Repair is almost always cheaper: reconnecting or sealing a run typically runs $150 – $900, while rebuilding a damaged trunk section runs $400 – $1,450. Full duct replacement only makes sense when the system is so degraded that patching it would just push the problem down the line. A free estimate will tell you which side you’re on.
How much does it cost to fix a disconnected air duct in League City?
Reconnecting a disconnected flex run in League City typically costs $350 – $900. The price depends on where the run sits, how much attic you have to cross to reach it, and whether the run needs replacing rather than just refitting. Call (866) 942-5170 to get a number for your house.
Can you come today?
Often, yes. We answer 24/7 and dispatch runs from 7am to 7pm, Sunday through Friday, with same-day service available. Call (866) 942-5170 and we’ll give you a time.
Do you repair ducts you didn’t install?
Yes. We work on whatever system is in the house, including systems with Honeywell or Aprilaire filtration components already installed. We don’t tear out or bypass premium equipment that’s doing its job.
What if my ducts are full of mold or heavy debris?
Ducts affected by mold or post-renovation debris need containment work before repair, which affects price. We use Abatement Technologies containment equipment built for that environment, and Rotobrush and Nikro HEPA systems capture the debris rather than redistributing it through the house. Call (866) 942-5170 to schedule an inspection.
Get a Free Estimate on Duct Repair and Sealing in League City
If your ducts are leaking, disconnected, or pulling attic air into the house, seal and repair them before the next cooling season hits. We do the job with the same contractor-grade equipment restoration professionals use: Rotobrush brush-and-vacuum systems and Nikro HEPA-rated vacuums, plus Abatement Technologies containment gear when the ducts call for it. And because we also handle dryer vent cleaning as a fire-safety service, we can check that side of the system while we’re there.
Call (866) 942-5170 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Pricing is per job by written estimate, and same-day service is often available.
Pricing reflects the League City market as of 2026. Duct Cleaning League City offers free estimates – call (866) 942-5170.
Written by the team at Duct Cleaning League City.
What Our Customers Say
"My wife's allergies had been bad in this house since we moved in. It's been two months since they did the ducts and it's noticeably better. Not a miracle, but real."
- Doug Doyle"Told me straight that our ducts were in decent shape and didn't need doing every year like the mailer companies claim."
- Cedric Ellison"Two guys, about three hours, plastic down at every register, and they wiped the vent covers before putting them back."
- Claudia Morales